Microchip PIC24FJ1024GB606-I/MR

PIC24FJ1024GB606-I/MR Description générale

One of the standout features of the PIC24FJ1024GB606-I/MR is its dual-partition Flash with Live Update capability. This allows for the simultaneous programming of one partition while executing application code from the other, enabling seamless over-the-air firmware updates. This not only provides a cost-effective solution for updating applications but also ensures reliability and security

Caractéristiques

CPU
• Modified Harvard Architecture
• Up to 16 MIPS Operation @ 32 MHz
• 8 MHz Internal Oscillator:
• 96 MHz PLL option
• Multiple clock divide options
• Run-time self-calibration capability for maintaining better than ±0.20% accuracy
• Fast start-up
• 17-Bit x 17-Bit Single-Cycle Hardware Fractional/Integer Multiplier
• 32-Bit by 16-Bit Hardware Divider
• 16 x 16-Bit Working Register Array
• C Compiler Optimized Instruction Set Architecture
• Two Address Generation Units for Separate Read and Write Addressing of Data Memory

Live Update
• Dual Partition Flash with Live Update Capability
• Capable of Holding Two Independent Software Applications, including Bootloader
• Permits Simultaneous Programming of One Partition while Executing Application Code from the Other
• Allows Run-Time Switching Between Active Partitions

Low-Power Features
• Sleep and Idle modes Selectively Shut Down Peripherals and/or Core for Substantial Power Reduction and Fast Wake-up
• Doze mode Allows CPU to Run at a Lower Clock Speed than Peripherals
• Alternate Clock modes Allow On-the-Fly Switching to a Lower Clock Speed for Selective Power Reduction

Universal Serial Bus (USB) Features
• USB v2.0 On-The-Go (OTG) Compliant
• USB Device mode Operation from FRC Oscillator – No Crystal Oscillator Required
• Low-Speed (1.5 Mb/s) and Full-Speed (12 Mb/s) USB Operation in Host mode
• Supports up to 32 Endpoints (16 bidirectional)
• Supports Control, Interrupt, Isochronous and Bulk Transfers
• On-Chip Pull-up and Pull-Down Resistors

Analog Features
• 10/12-Bit, up to 24-Channel Analog-to-Digital (A/D) Converter:
• 12-bit conversion rate of 200 ksps
• Auto-scan and threshold compare features
• Conversion available during Sleep
• Three Rail-to-Rail, Enhanced Analog Comparators with Programmable Input/Output Configuration
• Charge Time Measurement Unit (CTMU):
• Used for capacitive touch sensing, up to 24 channels
• Time measurement down to 100 ps resolution

Peripheral Features
• Peripheral Pin Select (PPS) –Allows Independent I/O Mapping of Many Peripherals
• Eight-Channel DMA Supports All Peripheral modules
• Six Input Capture modules, Each with a Dedicated 16-Bit Timer
• Six Output Compare/PWM modules, Each with a Dedicated 16-Bit Timer
• Four Single Output CCPs (SCCPs) and Three Multiple Output CCPs (MCCPs)
• Enhanced Parallel Master/Slave Port (EPMP/EPSP)
• Hardware Real-Time Clock/Calendar (RTCC) with Timestamping
• Programmable 32-Bit Cyclic Redundancy Check (CRC) Generator
• Four Configurable Logic Cells (CLCs)
• 5.5V Tolerant Inputs on Multiple I/O Pins

Caractéristiques